Table of Contents
If you power cycle the machine because of weird errors, you must leave the machine turned off for a minimum of 10 minutes
The die roll won't stop in the correct location
- Restart the machine. Took cover off both sides of die roll and could not locate a limit, prox, photo eye or anything that would fix the problem. Restarting the machine got the roll back in sync.
Safety Reset for counter ejector
* 
Blowing ink out of suction fan during machine washout
- Missing dust covers — have production replace them.
Anilox roll won't go up on print section
- have operator setup on a different job and let the machine go through its setup. Once setup is complete, have operator go back and setup on original job. This should clear the error.
Paper height fingers won't move
- have operator check and make sure no e-stops are made in print section, print doors are fully closed, etc
- error preventing operation should appear on maintenance screen
figure out how to get to maintenance screen