Trace:
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| j_l [2022/10/31 06:28] – phil | j_l [2024/05/27 15:09] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | * [[Setting up the glue after a power cycle]] | + | * [[J&L Machine password]] |
| + | * [[J&L Mosca pass]] | ||
| + | | ||
| + | * [[J&L Troubleshooting]] | ||
| + | * [[J&L Belts]] | ||
| + | * [[J&L Safety Relay Contacts Jumper]] | ||
| - | ====== Troubleshooting ====== | ||
| - | |||
| - | * **Back tab won't bend up** | ||
| - | * Prox switch isn't sensing leading edge of cardboard sheet | ||
| - | * Upper bar doesn' | ||
| - | * **Sheets going through crooked** | ||
| - | * Fingers are too tight on feeder | ||
| - | * Fingers should be 1.5 times sheet thickness | ||
| - | * **Backstop won't come down on bander** | ||
| - | * Backstop is not enabled on control panel (need to get picture of control) | ||
| - | |||