Differences

This shows you the differences between two versions of the page.

--- expertcut_troubleshooting [2023/06/14 04:58] – created phil
+++ expertcut_troubleshooting [2024/05/27 15:09] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
-  * **If you power cycle the machine because of weird errors, you must leave the machine turned off for a //minimum// of 10 minutes**
+**If you power cycle the machine because of weird errors, you must leave the machine turned off for a //minimum// of 10 minutes**
+-----
+====== Machine faults out with F303 Error in Feed Section of Flat Die Cut ======
+{{ :resizedimage_2023-10-26_04-21-27_2002.jpg?400 |}}
+If you have this error on the HMI, you have to //simultaneously// press both green buttons (pictured below) to re-prime the lubrication lines and clear the error.
+{{ :2023-10-26_04_52_18.png?400 |}}
+The alarm will sound continuously for a few seconds while it goes through its cycle.
+Doing this once may not clear the error.  Operator repeated this cycle five times before error went completely away.
+Operator also stated that sometimes you have to push both green buttons, //and also//, the blue button between them, //simultaneously//.
+====== Outside suction cups on flexo section won't pop up ======
+  * vanes are broken in one of the vacuum pumps
+  * the side guides are in too tight.  The large outer suction cups won't actuate if the side guides are in too close.