Differences

This shows you the differences between two versions of the page.

--- dro [2023/01/13 05:00] – phil
+++ dro [2025/01/22 06:27] (current) – phil
@@ Line 1: / Line 1: @@
- * [[compression section]]
+  * AG Stacker pass: 6012
+  * [[load former user/pass]]
+  * [[robot]]
+  * [[getting_encoders_back_in_range|Getting the encoder back in range]]
+  * [[changing_the_cam_depth_on_supply_pump|Changing the cam depth on supply pump]]
+  * {{ :layboybeltwelder.pdf |LayBoy Belt Welding Procedure}}
+  * [[DRO Troubleshooting]]
+  * [[DRO anilox roll change]]
+  * {{:dro-replace_the_coating_on_martin_feed_rollers.pdf |DRO feed roller cover change}}
+  * [[Cover location for Jackscrew to adjust parallel for feed roll]]
- * {{ :layboybeltwelder.pdf |LayBoy Belt Welding Procedure}}
------
-  * {{:imagepipe_0.jpg}}
-     * Schneider Electric Altistart 22
-     * to clear faults press 'up arrow + down arrow + ENT' simultaneously
-     * 'SSCr' error: no current detected (unwired)
-     * 'OLF' error: overload fault
-        * Allow the motor to cool and the ATS22 to timeout 10-15minutes before resetting the fault
-        * Check the ACC and tHP settings in the SET menu. If appropriate, increase either/both.
-----
-HMI password: 6012
----
-[[Production hit e-stop and now machine won't run]]
----
-AG stacker depth can't be greater than 19