Differences

This shows you the differences between two versions of the page.

--- 924_troubleshooting [2023/01/26 12:13] – created phil
+++ 924_troubleshooting [2024/05/27 15:09] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
-  * **The die roll won't stop in the correct location**
+==== If you power cycle the machine because of weird errors, you must leave the machine turned off for a minimum of 10 minutes ====
+  * [[Yellow, keyed E-stop on 924 loader has been pressed and won't reset]]
+==== The die roll won't stop in the correct location ====
+     * Restart the machine.  Took cover off both sides of die roll and could not locate a limit, prox, photo eye or anything that would fix the problem. Restarting the machine got the roll back in sync.
+==== Safety Reset for counter ejector ====
+ * {{ :screenshot_20230417_235718.jpg?400 |}}
+==== Blowing ink out of suction fan during machine washout ====
+     * Missing dust covers — have production replace them.
+==== Anilox roll won't go up on print section ====
+     * have operator setup on a different job and let the machine go through its setup.  Once setup is complete, have operator go back and setup on original job.  This should clear the error.
+==== Paper height fingers won't move ====
+  * have operator check and make sure no e-stops are made in print section, print doors are fully closed, etc
+  * error preventing operation should appear on maintenance screen
+  * FIXME figure out how to get to maintenance screen