Wiki

Trace:

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
924_encoders [2023/08/22 07:57] – phil924_encoders [2025/01/22 05:50] (current) – phil
Line 6: Line 6:
   * dipswitch position   * dipswitch position
     * 1-on 2-on 3-on 4-off 5-on 6-off     * 1-on 2-on 3-on 4-off 5-on 6-off
 +    * {{ :prescorer-encoder-dipswitches-924.jpg?400 |}}
  
 When you replace the encoder, you need to ensure the dipswitches are set to the above positions. When you replace the encoder, you need to ensure the dipswitches are set to the above positions.
Line 12: Line 13:
  
 The problem is that the encoder count is so far out of range that it will not display on the HMI.  You must, by hand, turn the encoder numerous revolutions until the encoder count gets back in range.  You'll need a couple of people to relay the status from the screen while one person is off in the hole turning the encoder by hand. The problem is that the encoder count is so far out of range that it will not display on the HMI.  You must, by hand, turn the encoder numerous revolutions until the encoder count gets back in range.  You'll need a couple of people to relay the status from the screen while one person is off in the hole turning the encoder by hand.
- 
-As of writing this, nobody know what the maximum and minimum numbers are supposed to be.  We are fairly sure that the encoder is calibrated correctly but we're not sure.