* **Back tab won't bend up**
     * Prox switch isn't sensing leading edge of cardboard sheet
     * Upper bar doesn't have brake turned on
  * **Sheets going through crooked**
     * Fingers are too tight on feeder
     * Fingers should be 1.5 times sheet thickness
  * **Backstop won't come down on bander**
     * Backstop is not enabled on control panel (need to get picture of control) FIXME
   * **Excessive Following — 2000 Backfold Drive**
      * //2000 Up Angle// is too high — reduce angle{{ :resizedimage20230509_004227.jpg?400 |}}