**If you power cycle the machine because of weird errors, you must leave the machine turned off for a //minimum// of 10 minutes**

-----

====== Machine faults out with F303 Error in Feed Section of Flat Die Cut ======
{{ :resizedimage_2023-10-26_04-21-27_2002.jpg?400 |}}

If you have this error on the HMI, you have to //simultaneously// press both green buttons (pictured below) to re-prime the lubrication lines and clear the error.

{{ :2023-10-26_04_52_18.png?400 |}}

The alarm will sound continuously for a few seconds while it goes through its cycle.

Doing this once may not clear the error.  Operator repeated this cycle five times before error went completely away.

Operator also stated that sometimes you have to push both green buttons, //and also//, the blue button between them, //simultaneously//.


====== Outside suction cups on flexo section won't pop up ======
  * vanes are broken in one of the vacuum pumps
  * the side guides are in too tight.  The large outer suction cups won't actuate if the side guides are in too close.