* **If you power cycle the machine because of weird errors, you must leave the machine turned off for a //minimum// of 10 minutes**
  * **AG stacker table extension will not retract/retracts //very// slowly**
    *  depth can't be greater than 19
  * **Secondary lift table will not lift up and down**
    * BCS Auto Position needs to be turned on so both tables will raise for bundle breaker
  * [[door limit won't light up]]
  * [[compression section]]
  * [[Feeder vacuum fan VFD troubleshooting]]
  * [[Production hit e-stop and now machine won't run]]
  * [[Machine breaker turns off not due to high current]]
  * **Bundle breaker faults with break fault**
     * If the bundle is an irregular shape, when it breaks, it may not be clearing the photo eye in time.  You can //lower// the across measurement in the setup and it will fix this.